CPU Heatspreader Lapping

Mike SchroppComputers 5599 Comments

I’ve been busy as of late trying to optimize my current system for Grid computing. This means 24/7 operation at 100% CPU and GPU load. My system was previously overclocked and setup without any real purpose other than better productivity and daily usage. I had not really pushed it that hard and had a somewhat mild overclock.

With the recent change towards optimizing my setup for Grid Computing I decided to push my overclock a little harder. On top of that, I also plan on leaving my computer running 24/7. These two things mean I needed to re-evaluate my cooling setup to ensure that I would be able to keep my temps in check.

My current computer setup is a AMD x4 940BE processor with a XIGMATEK HDT-S1283 cooler. The case is an Antec 900 with the stock Antec fans swapped out and replaced with higher flowing Silverstone fans. My previously CPU overclock around 3.4Ghz. I never really tinkered too much with it much before. I have another rig that has a 4.0Ghz Intel C2D that was my primary overclocking toy.

I decided to push my AMD setup closer to 3.8 Ghz since I knew that would help a little with my points per day production for Grid Computing. This required a bit of a voltage bump and subsequently a little more heat. After loading up Prime95 and doing some stressing I found that my temps were running around 50-51c. Not bad, but something I thought I could improve upon. I decided the easiest way would be to lap the heat spreader on the CPU (which I’ve done in the past) and found it to be worth a couple of degrees.

Since I was going to be lapping the CPU heatspreader I figured I would take the opportunity to measure the surface finish as well before and after. The main purpose of lapping the CPU heatspreader is to make sure the surface is perfectly flat so that there is maximum contact with the CPU heatsink base. More contact equals better heat transfer. The surface finish is a secondary thing, and while I don’t believe it has anywhere near as much impact as the flatness, I do think there is some value in the finish. Using a profilometer I was able to measure the RA finish of the CPU heatspreader before and after lapping.

Starting with 600 grit sandpaper and working in steps (800 grit, 1200 grit, 1600 grit) and the finishing it off with a light touch of 2000 grit yielded some pretty good results. During the lapping process I found that the stock CPU heatspreader was not all that flat. While the stock CPU heatspreader looks flat to the naked eye, it’s pretty obvious after you start lapping that it is not.

Stock CPU-

AMD Phenom II CPU Heatspreader

CPU Stock

After lapping for a couple of minutes here is what you end up with.

Processor Heatspreader Lapping

CPU Heatspreader Initial Sanding

Here are my surface finish measurements before and after lapping. (RA finish in inches)

Stock12 RA
Fully Lapped3.1 RA

Again, I’m not sure how much the RA finish comes into play but as you can see the improvements are pretty good from lapping.

Finished CPU after lapping-

Lapped Processor Heatspreader

Finished CPU Heatspreader

Now for the numbers that matter most; the temps. Here are the results of my 6 hour stress tests using Prime95 and maxing all 4 cores out at 100%.

Stock CPU51.3c (Peak Temp)
Lapped CPU47.2c (Peak Temp)
Difference4.1c

All in all the lapping process returned some excellent results. I managed to drop my temps another 4c.  The temps I had before were not that bad but they were a little high for my liking. Being able to reduce my temps further makes me feel better about operating my computer 24/7. Plus I was able to up my overclock another 400Mhz on top of that .

Facebook29.2k
Twitter13.2k
Pinterest7.1k
Pinterest
Pinterest
LinkedIn2.1k
RSS813
Follow by Email2.6k

Comments 5,599

  1. What i don’t understood is actually how you
    are now not actually a lot more smartly-liked than you might be right now.
    You’re very intelligent. You understand thus considerably on the subject of this matter, produced me in my opinion imagine it
    from so many numerous angles. Its like men and women are not interested except it’s
    something to accomplish with Lady gaga! Your own stuffs great.
    Always deal with it up!

  2. Excellent goods from you, man. I have understand your stuff previous to and you’re just too magnificent.
    I really like what you’ve acquired here, certainly like what you are
    saying and the way in which you say it. You make it enjoyable and you still
    take care of to keep it wise. I cant wait to read much more from
    you. This is really a tremendous website.

  3. Thank you, I’ve recently been looking for information about this subject for a long time and yours is the best I have found
    out till now. However, what in regards to the conclusion? Are
    you sure in regards to the source?

  4. When someone writes an post he/she keeps the thought of a user in his/her
    brain that how a user can know it. Thus that’s why this article is outstdanding.
    Thanks!

  5. I was pretty pleased to find this great site. I want to to thank you
    for ones time for this fantastic read!! I definitely liked every part
    of it and i also have you saved as a favorite to
    look at new information in your web site.

  6. whoah this weblog is fantastic i love reading your articles.
    Keep up the great work! You know, lots of individuals are searching around for this info, you could
    aid them greatly.

  7. Write more, thats all I have to say. Literally, it seems
    as though you relied on the video to make your point.
    You clearly know what youre talking about, why
    waste your intelligence on just posting videos to your weblog when you could be giving us
    something enlightening to read?

  8. Wonderful goods from you, man. I’ve remember your stuff previous to and you’re simply extremely
    wonderful. I really like what you have obtained here, really
    like what you are saying and the way in which during which you are saying it.
    You’re making it enjoyable and you still take
    care of to keep it smart. I can’t wait to read
    far more from you. This is actually a great website.

  9. Hey! Would you mind if I share your blog with my zynga group?
    There’s a lot of people that I think would really
    enjoy your content. Please let me know. Cheers

  10. Thank you for any other great article. Where else could anyone get that kind of information in such a perfect manner of
    writing? I’ve a presentation next week, and I am on the search for such information.

  11. 「古本屋が新聞の第一面を飾るなんて、そうそうあることじゃない」 「広告は信じてないんだと思ってましたが」とオーブリーはいった. 「わたしが信じている広告は、金のかからない広告だよ」 オーブリーは大破した店内を見て微笑んだ.ダッチワイフ

Leave a Reply

Your email address will not be published. Required fields are marked *